Portable EV chargers and granny chargers


Cord EVIRA Pro Portable Charger

Cord Plus Portable Charger

Cord Plus Type 1 Portable Charger

Type 1 Portable EV Charger

Type 2 Portable EV Charger

Wall Mount For Portable Charger
The Short Answer
A granny charger plugs your car into an ordinary 3-pin socket. It's a backup and a top-up, not your everyday charger: at 2.3kW (10A) it adds about 23kWh in a 10-hour night. We'd keep one in the boot, and get a home charger fitted for daily charging.
Plug it straight into the wall, never an extension lead, and ideally into a socket made for EV charging on its own circuit. Ours start at £121.99. If you have a 32A commando socket, a portable charger can do up to 7kW (from £199.99), and more on three-phase if your car takes it.
How long will it take?
Set your car's battery size and how much you want to add. Both are in your handbook or the car's app.
Adding 36kWh at 2.3kW takes at least 15 hours 39 minutes.
In a 10-hour night it adds about 23kWh. Charging slows as the battery nears full, so the last part takes longer than this.
3-pin or commando?

| Socket | Power | Our chargers |
|---|---|---|
| UK 3-pin | Up to 2.3kW (10A) | Cord Plus (6A, 8A or 10A, from £121.99), our built-to-order charger (from £151.99), Cord EVIRA Multi |
| Commando (CEE), 32A single-phase | Up to 7.4kW if your car takes it | Our built-to-order charger (from £215.99), Cord EVIRA 7.4kW (from £199.99) |
| Commando (CEE), 16A three-phase | 11kW for a three-phase car that takes 11kW; a single-phase car gets 3.7kW | Cord EVIRA 11kW (from £239.99) |
| Commando (CEE), 32A three-phase | Up to 22kW for a three-phase car that takes it; a single-phase car gets up to 7.4kW | Cord EVIRA 22kW (from £279.99) |
Commando sockets are the round industrial sockets you find in garages, workshops and on sites. The Cord EVIRA Multi (£399.99) comes with a 3-pin plug and three commando plugs, so it fits every socket in the table. Your car's on-board charger sets the limit: a car that charges on a single phase gets one phase's worth from a three-phase socket. Your car's handbook or spec sheet should say whether it's single or three-phase.
Is a granny charger safe?
It can be, if the socket is up to it. Electrical Safety First says the long, heavy load of charging an EV is likely to be more than a standard socket and its wiring are designed for. Sockets made for EV charging are tougher, marked BS1363/EV, and should be on their own circuit. Its advice: the safest way to charge at home is a dedicated charge point.
- plug straight into the wall: never an extension lead (the maker of our Cord chargers says the same), so buy a cable long enough to reach;
- use a socket in good condition, ideally an EV-rated one on its own circuit;
- check the cable and plug for damage, and stop using them if there is any;
- if you're not sure a socket is up to it, have an electrician check it.
Common questions
How we checked this
Every figure and rule on this page was checked against its source on 13 November 2026. We recheck them every month.
- Electric vehicles: safety advice (Electrical Safety First, official; read 13 November 2026)
- The Electric Vehicles (Smart Charge Points) Regulations 2021, regulation 3: application (legislation.gov.uk, official; read 13 November 2026)
- Charging your business's electric vehicles (Energy Saving Trust, official; read 14 November 2026)
- Fleet decarbonisation toolkit: types of chargers (Energy Saving Trust, official; read 13 November 2026)
- Cord EVIRA portable professional EV charger (Cord, industry; read 13 November 2026)
- Cord Plus portable (granny) EV charger 2.3kW 5m Type 2 (Cord, industry; read 13 November 2026)
- Octopus Go (Octopus Energy, industry; read 14 November 2026)
- Mobile Connector (Tesla, industry; read 14 November 2026)

Gavin Rogers
Director · Drives a BMW iX2
Gavin co-founded Power EV alongside EV Charge Cable, a specialist EV charging cable retailer. Between the two sites, the team covers the full home-charging picture: finding a qualified installer and getting the right cable to go with the charger.
Meet the team